For safety and battery conservation, the speed of the Unagi Model One is limited to 15.5 mph from the factory, however, for the more daring user, this top speed can be extended to 20 mph. The explanation below should guide you through the process removing the speed restriction.
To remove the electronic speed limiter on V3 units to reach 20 mph, please do the following:
- Start with the scooter powered on and set the speed to mode 1, with only a single motor selected.
- Hold down the brake and accelerator and then simultaneously push the power button 10 times.
- There should be a beep if successful. Set the scooter to Speed Mode 3.
Please note: It can often take three or four attempts for this process to be successful. Repeating this process after the speed limiter has been successfully turned off will result in the feature being turned back on.
A little note about safety...
There are very few occasions where it is a requirement for the added speed so we would ask for your consideration for safety when removing this feature. If you have any further unanswered queries, please do submit a ticket and one of our customer service agents will be with you shortly.